summaryrefslogtreecommitdiff
path: root/drivers/usb/pd (unfollow)
Commit message (Expand)Author
2020-04-18usb: pd: qpnp-pdphy: Switch to hrtimer-based waitJack Pham
2019-01-18usb: pd: Don't reject sink request based on max currentJack Pham
2018-09-05USB: pd: Notify selfpowered state based on type C currentVijayavardhan Vennapusa
2018-07-27USB: pd: Send PS_RDY within tNewSrc after PS_RDY receivedVijayavardhan Vennapusa
2018-01-17usb: pd: avoid out-of-bounds access when reading PDOsJack Pham
2018-01-17usb: pd: ensure source hard reset is handled timelyJack Pham
2018-01-17usb: pd: Support revision 3.0 in sink-only modeHemant Kumar
2017-12-08usb: pd: qpnp-pdphy: move RX handling to hard IRQJack Pham
2017-12-07usb: pd: qpnp-pdphy: Remove rx_busy flagJack Pham
2017-12-07usb: pd: Avoid blocking wait in SRC_TRANSITION_TO_DEFAULTJack Pham
2017-12-07usb: pd: Send pending VDM message upon entering SNK/SRC_ReadyJack Pham
2017-09-08usb: pd: Add support to send PD 3.0 extended messagesHemant Kumar
2017-09-08usb: pd: Add support to handle alert message for PD 3.0Hemant Kumar
2017-09-08usb: pd: Add support for PD revision 3.0 control messagesHemant Kumar
2017-09-08usb: pd: send Not Supported message when operating in 3.0Jack Pham
2017-09-08usb: pd: support PD 3.0 extended messages with chunkingJack Pham
2017-08-10power: qpnp-smb2: use correct propertiesNicholas Troast
2017-08-09usb: pd: force disconnect upon unexpected SRC->SNK transitionJack Pham
2017-08-09usb: pd: avoid missed connection notificationJack Pham
2017-08-07usb: pd: simplify pd_phy_write() and pd_phy_signal() usageJack Pham
2017-08-03usb: pd: rename enum pd_msg_type to pd_sop_typeJack Pham
2017-07-17usb: pd: policy_engine: Add support to handle floating chargerHemant Kumar
2017-07-13USB: policy_engine: Enable VBUS after VCONN before PE_SRC_StartupVijayavardhan Vennapusa
2017-07-07usb: pd: Add delay before sending Source CapabilitiesJack Pham
2017-06-09Policy_engine: Add module parameter to disable PDVijayavardhan Vennapusa
2017-06-08PD: policy_engine: Add timeout for mode change through sysfsVijayavardhan Vennapusa
2017-06-07usb: pd: Increment MessageID only on successful TXJack Pham
2017-06-06usb: pdphy: Prevent sending when message is just receivedJack Pham
2017-06-06usb: pd: Keep PROP_PR_SWAP set during ERROR_RECOVERYJack Pham
2017-06-06usb: pd: Set PD_IN_HARD_RESET as soon as hard reset receivedJack Pham
2017-06-05policy_engine: Add module parameter to start USB stackVijayavardhan Vennapusa
2017-06-01usb: pd: policy_engine: Handle spec revision properlyHemant Kumar
2017-05-31usb: pd: Rerun usbpd_sm if RX queue is not emptyJack Pham
2017-05-30usb: pd: policy_engine: Handle Get_Source_Cap properly from PE_SRC_ReadyHemant Kumar
2017-05-26usb: pd: Don't draw current during sink hard resetJack Pham
2017-05-26usb: pd: Notify charger when PR Swap is in progressJack Pham
2017-05-24usb: pd: policy_engine: Disable vconn first upon disconnectHemant Kumar
2017-05-18policy_engine: Don't allow MODE change if no active connectionVijayavardhan Vennapusa
2017-05-16usb: policy_engine: Close pd phy after exceeding SINK hard reset countHemant Kumar
2017-05-08usb: pdphy: Widen voltage range setting for VDD regulatorJack Pham
2017-05-03power: qcom: smb2: Add REAL_TYPE property for usb power_supplyFenglin Wu
2017-04-19usb: pd: Re-check for disconnect after PR swapJack Pham
2017-03-20usb: pd: Determine dual_role writeable based on PD capabilityJack Pham
2017-02-16usb: pd: Skip decreasing current when requesting the same PPSJack Pham
2017-02-14usb: pd: Fix probe failure in case of no sink capablities passedVijayavardhan Vennapusa
2017-02-13usb: pd: Avoid buffer overrun during msg_rxJack Pham
2017-02-10usb: pd: Update uevent parameters during hard resetJack Pham
2017-02-10usb: pd: Make select_pdo_store() wait until request goes throughJack Pham
2017-02-06usb: pd: Read sink capabilities from device treeJack Pham
2017-01-31usb: pd: Support Programmable Power Supply as sinkJack Pham
generated by cgit v1.2.3 (git 2.25.1) at 2026-01-28 15:13:18 +0000