diff options
5 files changed, 42 insertions, 2 deletions
diff --git a/Documentation/devicetree/bindings/fb/mdss-dsi-panel.txt b/Documentation/devicetree/bindings/fb/mdss-dsi-panel.txt index 0174306135c1..fd449f3fd8dc 100644 --- a/Documentation/devicetree/bindings/fb/mdss-dsi-panel.txt +++ b/Documentation/devicetree/bindings/fb/mdss-dsi-panel.txt @@ -365,6 +365,28 @@ the fps window. 2A/2B command. - qcom,dcs-cmd-by-left: Boolean to indicate that dcs command are sent through the left DSI controller only in a dual-dsi configuration +- qcom,mdss-dsi-panel-hdr-enabled: Boolean to indicate HDR support in panel. +- qcom,mdss-dsi-panel-hdr-color-primaries: + Array of 8 unsigned integers denoting chromaticity of panel.These + values are specified in nits units. The value range is 0 through 50000. + To obtain real chromacity, these values should be divided by factor of + 50000. The structure of array is defined in below order + value 1: x value of white chromaticity of display panel + value 2: y value of white chromaticity of display panel + value 3: x value of red chromaticity of display panel + value 4: y value of red chromaticity of display panel + value 5: x value of green chromaticity of display panel + value 6: y value of green chromaticity of display panel + value 7: x value of blue chromaticity of display panel + value 8: y value of blue chromaticity of display panel +- qcom,mdss-dsi-panel-peak-brightness: Maximum brightness supported by panel.In absence of maximum value + typical value becomes peak brightness. Value is specified in nits units. + To obtail real peak brightness, this value should be divided by factor of + 10000. +- qcom,mdss-dsi-panel-blackness-level: Blackness level supported by panel. Blackness level is defined as + ratio of peak brightness to contrast. Value is specified in nits units. + To obtail real blackness level, this value should be divided by factor of + 10000. - qcom,mdss-dsi-lp11-init: Boolean used to enable the DSI clocks and data lanes (low power 11) before issuing hardware reset line. - qcom,mdss-dsi-init-delay-us: Delay in microseconds(us) before performing any DSI activity in lp11 diff --git a/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dsc-wqxga-cmd.dtsi b/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dsc-wqxga-cmd.dtsi index 94ca102c9dc0..c80259bae5c0 100644 --- a/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dsc-wqxga-cmd.dtsi +++ b/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dsc-wqxga-cmd.dtsi @@ -53,7 +53,11 @@ qcom,mdss-dsi-te-check-enable; qcom,mdss-dsi-te-using-te-pin; qcom,ulps-enabled; - + qcom,mdss-dsi-panel-hdr-enabled; + qcom,mdss-dsi-panel-hdr-color-primaries = <14500 15500 32000 + 17000 15500 30000 8000 3000>; + qcom,mdss-dsi-panel-peak-brightness = <4200000>; + qcom,mdss-dsi-panel-blackness-level = <3230>; qcom,adjust-timer-wakeup-ms = <1>; qcom,mdss-dsi-on-command = [15 01 00 00 00 00 02 ff 10 15 01 00 00 00 00 02 fb 01 diff --git a/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dsc-wqxga-video.dtsi b/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dsc-wqxga-video.dtsi index 49130cc96f79..10713dd2490c 100644 --- a/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dsc-wqxga-video.dtsi +++ b/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dsc-wqxga-video.dtsi @@ -29,7 +29,11 @@ qcom,mdss-dsi-bpp = <24>; qcom,mdss-dsi-underflow-color = <0xff>; qcom,mdss-dsi-border-color = <0>; - + qcom,mdss-dsi-panel-hdr-enabled; + qcom,mdss-dsi-panel-hdr-color-primaries = <14500 15500 32000 + 17000 15500 30000 8000 3000>; + qcom,mdss-dsi-panel-peak-brightness = <4200000>; + qcom,mdss-dsi-panel-blackness-level = <3230>; qcom,mdss-dsi-on-command = [15 01 00 00 00 00 02 ff 10 15 01 00 00 00 00 02 fb 01 15 01 00 00 00 00 02 ba 03 diff --git a/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dualmipi-wqxga-cmd.dtsi b/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dualmipi-wqxga-cmd.dtsi index 10be9cc183f6..aeeaaa7ca6fb 100644 --- a/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dualmipi-wqxga-cmd.dtsi +++ b/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dualmipi-wqxga-cmd.dtsi @@ -61,6 +61,11 @@ qcom,mdss-dsi-te-check-enable; qcom,mdss-dsi-te-using-te-pin; qcom,ulps-enabled; + qcom,mdss-dsi-panel-hdr-enabled; + qcom,mdss-dsi-panel-hdr-color-primaries = <14500 15500 32000 + 17000 15500 30000 8000 3000>; + qcom,mdss-dsi-panel-peak-brightness = <4200000>; + qcom,mdss-dsi-panel-blackness-level = <3230>; qcom,mdss-dsi-on-command = [15 01 00 00 00 00 02 ff 10 15 01 00 00 00 00 02 fb 01 15 01 00 00 00 00 02 ba 03 diff --git a/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dualmipi-wqxga-video.dtsi b/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dualmipi-wqxga-video.dtsi index a2cac50325c5..f7122d34d8a9 100644 --- a/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dualmipi-wqxga-video.dtsi +++ b/arch/arm/boot/dts/qcom/dsi-panel-nt35597-dualmipi-wqxga-video.dtsi @@ -29,6 +29,11 @@ qcom,mdss-dsi-bpp = <24>; qcom,mdss-dsi-underflow-color = <0xff>; qcom,mdss-dsi-border-color = <0>; + qcom,mdss-dsi-panel-hdr-enabled; + qcom,mdss-dsi-panel-hdr-color-primaries = <14500 15500 32000 + 17000 15500 30000 8000 3000>; + qcom,mdss-dsi-panel-peak-brightness = <4200000>; + qcom,mdss-dsi-panel-blackness-level = <3230>; qcom,mdss-dsi-on-command = [15 01 00 00 00 00 02 ff 10 15 01 00 00 00 00 02 fb 01 15 01 00 00 00 00 02 ba 03 |