Merge remote-tracking branch 'origin/x86/fpu' into queue/x86/cpu

Use the union of 3.10 x86/cpu and x86/fpu as baseline.

Signed-off-by: H. Peter Anvin <hpa@linux.intel.com>

1 files changed, 6 insertions, 6 deletions

diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h
index 72474e18f1e0..6aa238096622 100644
--- a/include/linux/pinctrl/pinconf-generic.h
+++ b/include/linux/pinctrl/pinconf-generic.h
@@ -37,17 +37,17 @@
  *	if it is 0, pull-down is disabled.
  * @PIN_CONFIG_DRIVE_PUSH_PULL: the pin will be driven actively high and
  *	low, this is the most typical case and is typically achieved with two
- *	active transistors on the output. Sending this config will enabale
+ *	active transistors on the output. Setting this config will enable
  *	push-pull mode, the argument is ignored.
  * @PIN_CONFIG_DRIVE_OPEN_DRAIN: the pin will be driven with open drain (open
  *	collector) which means it is usually wired with other output ports
- *	which are then pulled up with an external resistor. Sending this
- *	config will enabale open drain mode, the argument is ignored.
+ *	which are then pulled up with an external resistor. Setting this
+ *	config will enable open drain mode, the argument is ignored.
  * @PIN_CONFIG_DRIVE_OPEN_SOURCE: the pin will be driven with open source
- *	(open emitter). Sending this config will enabale open drain mode, the
+ *	(open emitter). Setting this config will enable open drain mode, the
  *	argument is ignored.
- * @PIN_CONFIG_DRIVE_STRENGTH: the pin will output the current passed as
- * 	argument. The argument is in mA.
+ * @PIN_CONFIG_DRIVE_STRENGTH: the pin will sink or source at most the current
+ *	passed as argument. The argument is in mA.
  * @PIN_CONFIG_INPUT_SCHMITT_ENABLE: control schmitt-trigger mode on the pin.
  *      If the argument != 0, schmitt-trigger mode is enabled. If it's 0,
  *      schmitt-trigger mode is disabled.