diff options
Diffstat (limited to 'drivers/usb/host/xhci-hub.c')
| -rw-r--r-- | drivers/usb/host/xhci-hub.c | 47 |
1 files changed, 31 insertions, 16 deletions
diff --git a/drivers/usb/host/xhci-hub.c b/drivers/usb/host/xhci-hub.c index 08bcc1f812cb..7029578ac09f 100644 --- a/drivers/usb/host/xhci-hub.c +++ b/drivers/usb/host/xhci-hub.c @@ -156,7 +156,6 @@ static void xhci_common_hub_descriptor(struct xhci_hcd *xhci, { u16 temp; - desc->bPwrOn2PwrGood = 10; /* xhci section 5.4.9 says 20ms max */ desc->bHubContrCurrent = 0; desc->bNbrPorts = ports; @@ -190,6 +189,7 @@ static void xhci_usb2_hub_descriptor(struct usb_hcd *hcd, struct xhci_hcd *xhci, desc->bDescriptorType = USB_DT_HUB; temp = 1 + (ports / 8); desc->bDescLength = USB_DT_HUB_NONVAR_SIZE + 2 * temp; + desc->bPwrOn2PwrGood = 10; /* xhci section 5.4.8 says 20ms */ /* The Device Removable bits are reported on a byte granularity. * If the port doesn't exist within that byte, the bit is set to 0. @@ -240,6 +240,7 @@ static void xhci_usb3_hub_descriptor(struct usb_hcd *hcd, struct xhci_hcd *xhci, xhci_common_hub_descriptor(xhci, desc, ports); desc->bDescriptorType = USB_DT_SS_HUB; desc->bDescLength = USB_DT_SS_HUB_SIZE; + desc->bPwrOn2PwrGood = 50; /* usb 3.1 may fail if less than 100ms */ /* header decode latency should be zero for roothubs, * see section 4.23.5.2. @@ -602,15 +603,6 @@ static void xhci_hub_report_usb3_link_state(struct xhci_hcd *xhci, { u32 pls = status_reg & PORT_PLS_MASK; - /* resume state is a xHCI internal state. - * Do not report it to usb core, instead, pretend to be U3, - * thus usb core knows it's not ready for transfer - */ - if (pls == XDEV_RESUME) { - *status |= USB_SS_PORT_LS_U3; - return; - } - /* When the CAS bit is set then warm reset * should be performed on port */ @@ -633,6 +625,16 @@ static void xhci_hub_report_usb3_link_state(struct xhci_hcd *xhci, pls |= USB_PORT_STAT_CONNECTION; } else { /* + * Resume state is an xHCI internal state. Do not report it to + * usb core, instead, pretend to be U3, thus usb core knows + * it's not ready for transfer. + */ + if (pls == XDEV_RESUME) { + *status |= USB_SS_PORT_LS_U3; + return; + } + + /* * If CAS bit isn't set but the Port is already at * Compliance Mode, fake a connection so the USB core * notices the Compliance state and resets the port. @@ -707,7 +709,7 @@ static u32 xhci_get_port_status(struct usb_hcd *hcd, struct xhci_bus_state *bus_state, __le32 __iomem **port_array, u16 wIndex, u32 raw_port_status, - unsigned long flags) + unsigned long *flags) __releases(&xhci->lock) __acquires(&xhci->lock) { @@ -739,6 +741,14 @@ static u32 xhci_get_port_status(struct usb_hcd *hcd, status |= USB_PORT_STAT_C_BH_RESET << 16; if ((raw_port_status & PORT_CEC)) status |= USB_PORT_STAT_C_CONFIG_ERROR << 16; + + /* USB3 remote wake resume signaling completed */ + if (bus_state->port_remote_wakeup & (1 << wIndex) && + (raw_port_status & PORT_PLS_MASK) != XDEV_RESUME && + (raw_port_status & PORT_PLS_MASK) != XDEV_RECOVERY) { + bus_state->port_remote_wakeup &= ~(1 << wIndex); + usb_hcd_end_port_resume(&hcd->self, wIndex); + } } if (hcd->speed < HCD_USB3) { @@ -789,12 +799,12 @@ static u32 xhci_get_port_status(struct usb_hcd *hcd, xhci_set_link_state(xhci, port_array, wIndex, XDEV_U0); - spin_unlock_irqrestore(&xhci->lock, flags); + spin_unlock_irqrestore(&xhci->lock, *flags); time_left = wait_for_completion_timeout( &bus_state->rexit_done[wIndex], msecs_to_jiffies( XHCI_MAX_REXIT_TIMEOUT_MS)); - spin_lock_irqsave(&xhci->lock, flags); + spin_lock_irqsave(&xhci->lock, *flags); if (time_left) { slot_id = xhci_find_slot_id_by_port(hcd, @@ -1086,7 +1096,7 @@ int xhci_hub_control(struct usb_hcd *hcd, u16 typeReq, u16 wValue, break; } status = xhci_get_port_status(hcd, bus_state, port_array, - wIndex, temp, flags); + wIndex, temp, &flags); if (status == 0xffffffff) goto error; @@ -1106,7 +1116,7 @@ int xhci_hub_control(struct usb_hcd *hcd, u16 typeReq, u16 wValue, } port_li = readl(port_array[wIndex] + PORTLI); status = xhci_get_ext_port_status(temp, port_li); - put_unaligned_le32(cpu_to_le32(status), &buf[4]); + put_unaligned_le32(status, &buf[4]); } break; case SetPortFeature: @@ -1468,11 +1478,12 @@ int xhci_hub_status_data(struct usb_hcd *hcd, char *buf) * Inform the usbcore about resume-in-progress by returning * a non-zero value even if there are no status changes. */ + spin_lock_irqsave(&xhci->lock, flags); + status = bus_state->resuming_ports; mask = PORT_CSC | PORT_PEC | PORT_OCC | PORT_PLC | PORT_WRC | PORT_CEC; - spin_lock_irqsave(&xhci->lock, flags); /* For each port, did anything change? If so, set that bit in buf. */ for (i = 0; i < max_ports; i++) { temp = readl(port_array[i]); @@ -1600,6 +1611,10 @@ int xhci_bus_suspend(struct usb_hcd *hcd) hcd->state = HC_STATE_SUSPENDED; bus_state->next_statechange = jiffies + msecs_to_jiffies(10); spin_unlock_irqrestore(&xhci->lock, flags); + + if (bus_state->bus_suspended) + usleep_range(5000, 10000); + return 0; } |